Tyre Repair Kits

• Model NO.: CC1351
• Trademark: Super Care
• Specification: Standard
• HS Code: 3506100090

• Material: PP, Metal, Rubber
• Transport Package: Standard Export Carton
• Origin: Ningbo, China

Products Detail

Why choose us?
Function and User Guide 
 1. The first step is to locate the offending foreign object in your tire.
  2. Remove the Object
  3. Put 2-3 drops of the rubber cement on the tip of the reamer and insert the reamer into the puncture. Work the reamer in and   out while twisting to clean and prep the puncture and apply the cement. This process will also enlarge the hole to that the           plug will fit through; because of this the first couple of insertions can be difficult. Repeat this process 2-3 times to make sure t     the puncture is clean and that there is enough cement in the wound. 
4. Take each end of the repair string(about 70mm long), this is the plug, and roll the center of the string into the needle eye.       Apply 2-3 drops of rubber cement to the end of the needle and 
Push the needle and repair string into the puncture (this can be tricky with smaller punctures) until only about a quarter-inch of the strip is sticking out of the tire's surface.
 5. Make a 1/4 turn with the  handle and pull the needle probe out of the tire. The patch should remain in the tire when you remove the probe.Trim the repair strip that is sticking out of the tire down to about 1/8 of an inch.
6.Use an air compressor to replace any air that may have leaked out of the tire. Your tire should be re-inflated and ready to get back onto the road.

Contact us
Ningbo Super Clean Co.,Ltd.
ADD: No.1, HouCang Industry Zone,
        West Section Yinxian Road, Ningbo China(315153)
TEL:0086-574-89020080,89020081
FAX:0086-574-88255300
Mobile:0086-13858225192
www.nbsuperclean.com
 
 









 

430 Stainless Steel Cut Wire Shot

Stainless Steel Cut Wire Shot is a very important Metal Abrasive.It is often utilized in wheel blasting processes when ferrous contamination of work piece is forbidden. When Blasting stainless work pieces or other metals need to be down as a pristine surface, stainless cut wire may be a very good metal abrasive to take into consideration. Stainless Steel Cut Wire Shot As Conditioned is usually used for shot peening processes on stainless steel or Inconel parts. Stainless steel cut wire can range in size from 0.15mm up to 3.0mm and possibly larger in special order circumstances.

Concerning stainless steel cut wire shot, it has a very bright surface, maintains its shape longer then cast abrasives and it has a dust free surface. Stainless Steel Cut Wire is available as cut or conditioned and with various chemical compositions.The bulk density of stainless steel cut wire shot is very high and must be taken into consideration in relation to its use in equipment. Suitable equipment must be selected to convey Stainless Steel Shot.

430 Stainless Steel Cut Wire Shot,Sus430Stainless Steel Cut Wire Shot,Ss430 Stainless Steel Shot,Astm430 Stainless Steel Cut Wire Shot

Longlived Metal Products Co ., Ltd , https://www.longlivedmetalproducts.com